Technology Details on Compound Fertilizer Granulator
1. The technical characteristics of compound fertilizer granulator, the granulation rate is more than 90%, and the specification is incomplete, it can also enter the pulping machine again for secondary processing, and the cylinder power is small. The shell is made of wear-resistant steel, which effectively extends the service life of the equipment.
2. The reducer of the granulator drives the belt through the motor. There is a pinion on the shaft of the reducer, which coincides with the teeth on the outer gear ring of the machine body. The barrel and the reducer are close to each other, and the material is removed from the bin or hopper. The conveyor belt is sent to the end of the barrel, the material is made into small granular material in the barrel, and the material is discharged from the barrel. The outlets at the other end are together. Through the continuous operation of the machine, mass production can be realized.
3. Power saving support roller bracket is used for support. The support frame is made of high quality carbon steel, which can fully bear the weight of the cylinder. Considering the large friction between the cylinder and the supporting wheel, it is intentionally used in this part. On the one hand, more wear-resistant materials can improve the integrity and stability of the equipment.
4. The transmission device is an important part that provides the main movement for the machine. The ring gear on the cylinder is driven by the motor and reducer on the rack.
5. The shelf is made of special non deformable special channel steel, which is used for dry connection, making the transmission device of the machine more complete and stable. This is a special molding machine, which can be made by rolling materials by chemical reaction in a certain liquid. Under the action of the cylinder, through the rolling of the cylinder, the material and small particles are extruded to form a sphere.
Precautions for using granulator fertilizer:
1. Always pay attention to the temperature change of the fuselage. When touching the strip with clean hands, raise the temperature immediately. Until the silver bar touches your hand, this is normal.
2. When the bearing part of the reducer is burned or accompanied with noise, it should be shut down for repair in time and refuel.
3. When the bearing parts at both ends of the main engine bearing chamber are hot or noisy, please stop the machine maintenance and add butter. During normal operation, the bearing cavity is filled with grease every 5-6 days.
4. Pay attention to find out the operation rules of the machine; for example, if the temperature of the machine is high or low, the speed is fast or slow, it can be handled in time according to the situation.
5. When the fuselage is unstable, check whether the gap between the couplings is too tight, and adjust and loosen it in time.