My Blog

My WordPress Blog

What Is the Cause of the Clogging of the Organic Fertilizer Equipment Pulverizer?

What Is the Cause of the Clogging of the Organic Fertilizer Equipment Pulverizer?

There are a lot of grinders in our daily life, such as laboratory jet grinders, organic fertilizer grinder machines, etc., but in the process of use, sometimes there will be some failures, such as clogging of the grinder, when it is blocked , How should we deal with it? In fact, clogging is a very common failure of the shredder during smashing, and the main reason is still caused by improper operation. The editor of the organic fertilizer equipment manufacturer will teach you some methods to deal with the clogging of the grinder.

semi wet material crusher details

Reasons and solutions for the clogging of the crusher of the organic fertilizer equipment:

  1. The feeding speed is too fast and the load increases, causing blockage. During the feeding process, pay attention to the deflection angle of the ammeter pointer at any time. If it exceeds the rated current, it indicates that the motor is overloaded, and the motor will be burnt if overloaded for a long time. When this happens, the feed door should be reduced or closed immediately, or the feed mode can be changed, and the feed volume can be controlled by adding the feeder. There are two types of feeders: manual and automatic. The user should choose the appropriate feeder according to the actual situation. Due to the high speed of the crusher, the large load, and the strong fluctuation of the load. Therefore, the current of the shredder is generally controlled at about 85% of the rated current.
  2. The discharging pipeline is not smooth or blocked and the feed is too fast, which will block the tuyere of the grinder equipment, and improper matching with the conveying equipment will cause the discharge pipeline to be blocked when the wind is weakened or there is no wind. After the fault is detected, the unmatched conveying equipment should be cleared first, and the feeding amount should be adjusted to make the equipment operate normally.
  3. Hammer fragments, aging, closed or broken screen mesh, and high water content of the crushed materials will block the crusher. The broken and severely aged hammers should be updated regularly, keep the crusher in good working condition, and check the screen regularly. The moisture content of the crushed material should be less than 14%, which can improve the production efficiency of G, and prevent the pulverizer machine from clogging. , Enhance the reliability of the crusher’s work.
Vertical Fertilizer Material Crushing Machines

Vertical Fertilizer Material Crushing Machines

The content of the above article is the method to deal with the clogging of the crusher of the organic fertilizer processing equipment. Only by solving the problem in time can the service life of the organic fertilizer processing equipment be longer.

Leave a Reply

Your email address will not be published. Required fields are marked *