My Blog

My WordPress Blog

Installation and Commissioning of Rotary Drum Granulating Machine

Installation and Commissioning of Rotary Drum Granulating Machine


After the machine shows up at the production line, it is introduced as per the mechanical cycle. It is called attention to that height and flat position, slanted establishment, tendency is 2-5 degrees (which can be changed by clients). The section and transmission casing of the machine have foot openings, which can be introduced on concrete.

The all out thickness of the pad plate between the base and the establishment of the machine should be close to 30-35 inches.

1)The tallness of each base is changed by the bamboo pad plate to arrive at the tendency of the chamber;

2)The change of each base is appropriate for setting the chamber on the section and changing the supporting wheel;

3)Installing the transmission part of the granulator;

4)After the change of the supporting wheel, transmission gadget and chamber is appropriate, the concrete is poured. Following 8-10 days, the concrete is set, the no-heap test is begun;

5)Commissioning technique for body position:

a.Install two equal steel wires on the full length of the left and right sides of the body. The breadth of the steel wires is 0.5-1mm and check the degree of the steel wires with a flat instrument.

b.Put down two line drops digression to the wheel belt along the different sides of the granulator on the wheel belt.

c.Measure the good ways from the wire to the drop to identify the body’s flat position.

d.Detecting the overall vertical height of the most noteworthy purposes of the two wheels to check the situation of the body on the vertical plane;

e.Adjust the undercarriage towing boat to make the body in the correct position;

2.No-load trial:

1)The temperature of the orientation should rise consistently for 8 hours without ground break. The temperature of the direction ought not be higher than 50 C toward the finish of the trial.

2)The commotion of cog wheels should be uniform, not high or low.

3)No genuine wear and scraped spot of orientation will be seen in the wake of appointing.

More Information:

Leave a Reply

Your email address will not be published. Required fields are marked *