How to Install and Debug the Newly Purchased Double Roller Granulator?
Organic fertilizer dry rolling granulator is a new granulator equipment in organic fertilizer production plant, also known as dry powder granulator or organic fertilizer dry granulation machine. The reason why it is called organic fertilizer dry rolling granulator is that the equipment can directly compress and granulate the fermented powdered organic fertilizer during the granulation process, and the product can be packaged directly through the organic fertilizer packaging equipment after one molding. The process of drying and cooling after granulation in the traditional organic fertilizer production process is avoided.
Installation and commissioning of dry roller granulator for organic fertilizer:
- Installation:
After the newly purchased organic fertilizer dry process roller granulator arrives at the plant, the granulator is taken as the main machine, which is determined according to the number of units, and is installed in combination with the process flow chart to find out the elevation and horizontal placement. The machine frame has corner holes, which can be installed on the concrete.
- Debugging:
(1) Axial alignment: it has been adjusted during installation. Generally speaking, it is not possible to adjust it. When adjustment is needed, tighten or loosen the covers on both sides of the passive bearing seat, so as to push the displacement of the eccentric sleeve corresponding to the driving shaft roller.
(2) Adjustment of press roller clearance: sometimes it is necessary to increase the output or bite angle in production. At this time, the distance between the two pressing shafts can be increased. The distance between the driving shaft roller and the passive shaft can be increased. The steps are as follows: stop the machine, remove the upper frame of the two bearing blocks, and adjust the adjusting plate between the two bearing blocks to the required thickness.
(3) Adjustment of ball and socket: the ball and socket of the dry rolling granulator of organic fertilizer is formed by the concave and socket on the surface of the main roller, so there are problems of axial alignment and circumferential alignment;
(4) Axial alignment steps: loosen the 6 connecting bolts between the driven gear and the adjusting sleeve, so that the adjusting sleeve and the driven gear are slightly separated. Since one ball and socket adjustment amount has been considered in the design, and two adjusting bolts are provided, the dislocation can be adjusted no matter how much the dislocation is.